Токарные канавочные резцы Mitsubishi для наружного и внутреннего точения GROOVING

Токарные канавочные резцы Mitsubishi для наружного и внутреннего точения GROOVING

Токарные канавочные резцы Mitsubishi для наружного и внутреннего точения GROOVING _ MACHINING RECOMMENDATIONS I Notes on multi-functional machining (MF,MS,MM and BM breakers) Machining narrow grooves Machining wide grooves lit is recommended to carry out plunging in several passes. Following the steps above makes it difficult for chips to elongate. This also improves the accuracy of workpiece wall surface. lit is recommended that cross-feed machining is used. Machining wide grooves ROUGHING Carry out grooving. Retract the tool approx 0.1mm. Carry out cross feed Carry out grooving. Carry out grooving to machining. Retract the tool approx the end point of the Retract the tool approx 0.1mm. corner radius. 0.1mm. Repeat the steps - . Machining of the wall surface, corner radius and bottom face should be carried out in one process. FINISHING Stop at the bottom of the comer radius. Machine the counter wall to the corner radius in one process. Finish machining. Precautions when finishing walls Jl I L D I ( R)\ ITo produce high accuracy walls using MS or MM breaker insert, do not cany out back turning. Plunging is recommended. Machining of a ring section 1 When a ring remains in a cross feed end process, finish cross feed machining 1 -1.5mm short of the end point, then remove the ring by plunging. 502 Mitsubishi Materials